非AWGN环境下调制类型自动识别

在非AWGN环境下，针对CW，AM，FM，OOK，PSK，QPSK，16QAM，FSK，MSK，SSB十种混合调制信号，对调制类型特征提取方法和自动识别算法进行了分析、综合、设计和计算机仿真。提出了梯层电平分析方法、频率瞬时信号分析、剔除载波的归一化能量分析、平方后信号的频谱分析、四次方后的信号频谱分析等方法。当SNR=10dB时，计算机仿真结果是正确识别率不低于95％，自动识别的平均处理时间为不超过10s。     

基于移动端多天线系统的无线衰落信道模型

根据当前无线移动通信对多天线移动接收端性能仿真的要求，讨论并建立了适于空时信号处理的移动端矢量信道模型。通过分析无线移动信道特点。研究了影响接收信号幅度相位的诸多因素，建立了相应的数学模型。并对随机参数选取进行了探讨。其中考虑到移动端接收信号到达角扩散的特点，采用GBSB椭圆模型产生了适于移动端接收信号仿真的随机角度，改进了一种瑞利衰落生成算法。最后信道的数值仿真结果符合理论和经验。同时，通过TD-SCDMA系统链路级仿真，也证明了该信道模型的有效性。     

ECAP细化晶粒法的仿真与分析

ECAP(Equal Channel Angular Extrusion)方法，是实现材料纯剪切变形的有效方法。本文采用有限元（FEA）分析软件ANSYS对Al的挤压过程进行仿真与分析。分析结果表明：外切角Φ、圆角半径、试样与凹模之间的摩擦系数、凹模本身的特性（如弹性模量、泊松比等）等等，对材料的变形量都有不同程度的影响。     

大平房油田曲流河储层沉积微相特征及注水调整研究

复杂断块大平房油田东营组储层为陆上曲流河相沉积类型，其中曲流河点坝相储集层为主要产油层，而该油田此相带储集层规模较小，表现为储层物性较差，连通性差，开采过程中生产动态复杂，造成注采体系不完善，水驱效果差，水驱采收率较低，通过以岩心分析资料和大量的测井、生产动态资料为基础，对各种沉积相标志的分析，研究了曲流河储集层微相组成及主要沉积微相特征，综合评价出Ⅱ、Ⅲ类储层，找出影响注水开发效果的各类因素，有针对性地对注采系统进行调整研究，提高水驱控制程度。     

A Novel Channel Predictor Based on Constrained Hidden Markov Model

1　Introduction　Linkadaptationtechniqueisnowwidelyrecognizedasakeysolutiontoincreasethespectralefficiencyofwire lesssystems[1～ 3] .GPRS ,EDGE ,cdma2 0 0 0andWCDMAallincludelinkadaptationasameanstopro videhigherdatarates[4～ 5] .Torealizethepotentialoflinkadaptation ,reliablechannel predictionisneces sary[6 ] .　Therearemanydifferentchannelpredictionmethodsavailablenow ,suchasLongRangePrediction(LRP) [6 ] ,predictionbasedonsubspacesignalprocess ingalgorithms[7] ,predictionbasedonFinit…     

1960年前黄河下游河槽淤积物粒径组成分析

利用1999年汛前深层钻孔取样资料和历年淤积实测大断面资料分析出1960年前无三门峡水库影响的“自然”水沙情况下,下游河道主槽淤积物中d≥0.1 mm以上泥沙占50.7%,比1960-1999年大30个百分点,这种泥沙在下游的淤积比高达83.1%,比0.05 mm以上泥沙的淤积比高39个百分点。指出应在黄河中游寻找出0.1 mm以上的粗泥沙集中来源区作为近期水土保持的重点区域。     

Design of High Speed AWGN Communication Channel Emulator

This paper presents a method for designing a high accuracy white gaussian noise generator suitable for communication channel emulation. The proposed solution is based on the combined use of the Box-Muller method and the central limit theorem. The resulting architecture provides a high accuracy AWGN with a low complexity architecture for a digital implementation in FPGA. The performance is studied by means of MATLAB simulations and various complexity figures are given.     

Determination of Boundary Shear Stress and Reynolds Shear Stress in Smooth Rectangular Channel Flows

A method for computing three-dimensional Reynolds shear stresses and boundary shear stress distribution in smooth rectangular channels is developed by applying an order of magnitude analysis to integrate the Reynolds equations. A simplified relationship between the lateral and vertical terms is hypothesized for which the Reynolds equations become solvable. This relationship has the form of a power law with an exponent of n = 1, 2, or infinity. The semiempirical equations for the boundary shear distribution and the distribution of Reynolds shear stresses are compared with measured data in open channels. The power-law exponent of 2 gave the best overall results while n=infinity gave good results near the boundary.     

Multi-User MIMO Mobile CDMA Uplink System Employing Turbo Coding and Joint Detection Through a Multipath Rayleigh Fading Channel

In this paper, a generalized multiple-input multiple-output (MIMO) antenna system that can be fitted to the uplink of a wireless communication system is considered for the general case of multi-user. At the transmitter, the information bits are Turbo coded, then interleaved and passed through a serial-to-parallel converter. The channel is assumed bad urban suffering from multipath Rayleigh fading resulting in inter-symbol and multiple access interferences (ISI and MAI). At the front-end of the receiver, a number of receiving antennas are used followed by a joint multi-user estimator based on the Minimum Mean Square Error Block Linear Equalizer (MMSE-BLE).Computer simulations demonstrate a significant performance improvement in both single user and multi-user cases.This paper depends in parts on that presented at the 11th European Wireless Conference, Cyprus, Nicosia, pp. 187–192, April 2005. Yasmine A. Fahmy was born in Guiza, Egypt, on June 4, 1976. She received the B.Sc., M.Sc. and Ph.D. degrees in Communication and Electronics engineering from Cairo University, Egypt on 1999, 2001 and 2005 respectively. She is presently an assistant professor at Cairo University, Egypt. Her current field of interest is wireless communication and channel estimation. Hebat-Allah M. Mourad received her B.Sc., M. Sc. and Ph.D. degrees in electrical communication engineering from Cairo University, Egypt, in 1983, 1987 and 1994 respectively. Since 1983, she has been with the Department of Electronics and Communications, Faculty of Engineering, Cairo University, and is currently associate professor there. Her research interests include optical fiber communications, mobile and satellite communications. Emad K. Al-Hussaini received his B.Sc degree in Electrical Communication Engineering from Ain-Shams University, Cairo, Egypt, in 1964 and his M.Sc and Ph.D. degrees from Cairo University, Giza, Egypt, in 1974 and 1977, respectively. From 1964 to 1970, he was with the General Egyptian Aeroorganization. Since 1970, he has been with the Department of Electronics and Communications, Faculty of Engineering, Cairo University, and is currently professor there. He was a research fellow at Imperial College, London, UK, and at the Moore School of Electrical Engineering, University of Pennsylvania, Philadelphia, PA, USA, in the academic years 1976/1977 and 1981/1982, respectively. In 1990, he received the Egyptian national encouragement award for outstanding engineering research. He has written several papers for technical international journals and conferences. His research interests include signal processing, fading channel communication, modulation, and cellular mobile radio systems. Dr Al-Hussaini is a senior member of IEEE. He is listed in Marquis Whos Who in the World and in the IBC (International Biographical Center, Cambridge) for outstanding people of the 20th century.     

带有块间串扰MC-CDMA的时域信道估计和多用户检测

本文把带有IBI的MC-CDMA系统等效解释为特殊的直接序列码分多址（DS-CDMA）系统，并给出了相应的时域信道估计方法和时域线性最小均方误差（MMSE）多用户检测方法。仿真实验表明了本文方法的性能。